Battery pack assembly bench
Check a batch of incoming cells, size a pack for your vehicle, then test your pack on a BMS bench and see what your choices do.
How this lab works
Check the incoming cells
A batch of 12 cells has arrived for a 4S2P pack. Measure each cell, then accept it or reject it. You need 8 good cells. Some cells in the batch are bad, the way it happens on a real line.
Size the pack
Pick the cell, the series and parallel count and the current your vehicle needs. The bench works out the voltage, energy, BMS rating, fuse, main wire and charger.
Test it on the BMS bench
The 8 cells you accepted are now a 4S2P pack on a smart BMS. Load it, charge it, watch the cells balance and add faults. If you passed a bad cell in step one, you will see it here.
Battery pack assembly bench
Voltesta, voltesta.com
1Check the incoming cells
Workshop rule used here: accept a cell when its voltage is within 20 mV of the batch middle value and its internal resistance is no more than 1.3 times the middle value. Reject any cell below 2.5 V, even if it looks fine.
Cell tester
Cell grading
| Cell | Voltage (V) | Internal resistance (mΩ) | Decision |
|---|
2Size the pack
Pick the cell, the series and parallel count and the current your vehicle needs. The bench works out the voltage, energy, BMS rating, fuse, main wire and charger.
Main wire uses a chassis-wiring table for short runs; derate for long or bundled wires. Strip uses a workshop rule of about 5 A per layer of 0.15 × 8 mm pure nickel. Check every part against its supplier's data sheet.
3Test it on the BMS bench
The 8 cells you accepted are now a 4S2P pack on a smart BMS. Load it, charge it, watch the cells balance and add faults. If you passed a bad cell in step one, you will see it here.
Accept 8 cells in step 1 and press Build to put your pack on the bench.
Group 1Group 2Group 3Group 4
Trip log
Observations
| Time | What the pack is doing | A | Pack voltage (V) | Lowest group (V) | Highest group (V) | Spread (mV) | °C |
|---|
Every value here comes from a teaching model running in your browser, with typical figures. They are not measurements from real hardware.
Standards this lab refers to
- AIS-156
- Indian safety rules for traction batteries in L-category vehicles (two- and three-wheelers).
- IS 16893
- Indian Standard for lithium-ion cells that drive electric road vehicles, covering performance and reliability tests.
- UN 38.3
- Tests that lithium cells and batteries must pass before they can be shipped.
Named for learning only. Voltesta does not claim approval or certification from any of these bodies.
Courses that teach this properly
Talk to Voltesta
Message us on WhatsApp in your own words. A message is ready for you to edit, and we reply within one working day.