Voltesta

What a BMS does, in plain words

, 2 min read

Every lithium-ion pack in an electric scooter or three-wheeler has a small circuit board called the BMS, the battery management system. You rarely see it, but it decides whether the pack is allowed to charge, allowed to give power, or must shut down.

It watches every cell

A pack is made of many cells. The BMS measures the voltage of each group of cells and the temperature at a few points in the pack. A healthy pack keeps every group close to the others.

For common NMC cells, full charge is usually around 4.2 V per cell and the safe lower limit is usually between 2.5 V and 3.0 V. LFP cells sit lower, at about 3.65 V full. Always follow the datasheet of the exact cell in the pack, because the BMS limits are set from it.

It switches power off when something is unsafe

If a cell goes too high while charging, too low while riding, gets too hot or too cold, or if the current is too high, the BMS opens its switches. The scooter suddenly stops or the charger stops charging. This is protection, not a fault in the BMS.

The usual protections are over-voltage, under-voltage, over-current in charge and discharge, short circuit and over- or under-temperature. The switches are normally MOSFETs on the negative side of the pack; some designs use a contactor.

It keeps the cells equal

Over many cycles, cells drift apart. Balancing brings the fullest cells down to match the rest, so that one cell does not limit the whole pack. You can watch this happen in the cell balancing experiment in the EV Lab.

It estimates how full the pack is

The percentage on the display is the state of charge. The BMS estimates it from voltage and from counting the current going in and out. Some systems also estimate state of health, which is how much capacity the pack still has compared with when it was new.

What this means in the workshop

A vehicle that cuts out at the same point every time, or a charger that stops early, often points to the BMS protecting one weak cell group. Measure each group before replacing anything, and never bypass a BMS to make a vehicle run.

Talk to Voltesta

Message us on WhatsApp in your own words. A message is ready for you to edit, and we reply within one working day.